Wiring To The Center Modules - Panasonic Attune WX-C3010 Installation Instructions Manual

5.3.2 Wiring to the Center Modules

1. Remove the terminal cover. Slide the front cover
downwards by pressing its arrow marked part and pull the
lower side of the cover toward you.
2. Insert a "minus" screwdriver in the slot as illustrated and
remove the terminal socket from the main unit.
3. Connect the wiring material to the terminal socket. Use
the "minus" screwdriver and loosen the screw located on
the upper surface of the terminal socket. Peel off the
sheath from the tip of the wiring material and insert the
cable tip in the terminal socket. Firmly tighten the
loosened screw by means of the "minus" screwdriver.
Repeat the above-mentioned same procedure for each
terminal.
Notes:
• Process the wires according to the following:
Recommended wire type: AWG 28 - 16 (Do not use
soldered wires.) Length to be stripped: 7 mm ± 1 mm
{9/32" ± 1/16"} Diameter of screw: ø 2 mm {3/32"}
• Check to be sure that the wires are securely connected.
4. Mount the cabled socket on the main unit.
Note: Insert the socket firmly into the main unit.
5. Slide the front cover from the bottom and mount it on the
main unit.
Note: Surely attach the front cover to the main unit.