Advertisement
Partner: BiAmp
Model: AudiaFlex & Nexia
Device Type: DSP
CRESTRON HARDWARE REQUIRED:
SETUP OF CRESTRON HARDWARE:
VENDOR FIRMWARE:
CONTROL:
Volume_Up/Down
New_Volume_Level
Send_New_Level
Poll_Level
From_Processor
C2-COM, C2I-*-COM*, C2ENET-1/2, C2I-*ENET-*
RS232
Baud: 38400
Parity: N
Data Bits: 8
Stop Bits: 1
TCP/IP
Port 23 (Telnet)
4.560
D
Press and hold to adjust the volume level.
Analog value of volume level. This is the signed dB level to set the volume level to. Will be
sent when the Send_New_Level input is pulsed. This will allow preset values to be sent to
the BiAmp. Valid range is Volume_Upper_Limit to Volume_Lower_Limit. Default range is -
A
100 to +12.
NOTE: THIS INPUT IS NOT DESIGNED TO BE USED WITH A RAMP SYMBOL IN SIMPL
WINDOWS. IT IS ONLY DESIGNED TO BE USED FOR PRESET LEVELS.
Pulse to send the volume entered in the New_Volume_Level input. This will allow preset
D
values to be sent to the BiAmp.
D
Pulse to poll for the current value.
Serial data signal to be routed from one of the To_Modules[*] outputs on the BiAmp
S
AudiaFlex + Nexia Command Processor Serial v7.5.1 module or the BiAmp AudiaFlex +
Nexia Command Processor IP v7.5.1 module.
Advertisement
