Crestron PYNG-HUB Do Manual

DO
PYNG-HUB
Crestron Pyng Control Everything
®
DO Install the PYNG-HUB
The Crestron ® PYNG-HUB can be mounted on a DIN rail, mounted to any flat surface, or placed on a
tabletop. If necessary, use screws that are applicable for the mounting scenario. For details, refer to
the illustrations below.
NOTE: The PYNG-HUB can also be rack mounted. For rack mount installation, refer to the
RMK-IFE-1U Installation Guide (Doc. 7627) at www.crestron.com/manuals.
DIN Rail Mounting
NOTE: Do not use the supplied screws to mount the bracket to the bottom of the PYNG-HUB if the
device will be mounted on a DIN rail. Removing the PYNG-HUB from the DIN rail will not be possible.
DO Connect the Device
Connect the PYNG-HUB to the wireless router via the included Ethernet cable. To turn on the
PYNG-HUB, connect the power supply to the PYNG-HUB and then to an electrical outlet. The
PYNG-HUB can also be wired without the power supply and powered via Power over Ethernet (PoE).
For details, refer to the illustrations that follow.
Wire with Power Supply
24 V 0.75A:
included
power pack
GUIDE
Control Hub
®
Flat Surface Mounting
LAN:
From 10BASE-T /
100BASE-TX
Ethernet to LAN
Check the Box
DO
QTY PRODUCT
1 Bracket, Mounting, Integrated DIN Rail Clip
1 Cable, Ethernet, CAT5e, 5' (1.52 m)
1 Connector, 4-Pin
1 Power Pack, 24 Vdc 0.75 A, 100-240 Vac
2 Screw, 6-32 x 3/8", Pan Head, Phillips
Wire with PoE
DO Download the Pyng App from the App Store
NOTE: An iTunes ® account is required to download the Crestron Pyng app. Refer to
support.apple.com/kb/HT2731 for help setting up an account.
device home screen, tap the App Store icon (
1. On the iPad ®
2. Search for the app:
a. Tap the search field.
b. Enter the search term Crestron Pyng.
3. Tap the icon, the Crestron Pyng app, and follow the prompts to download it. The app
downloads to the device. The app icon appears on the home screen and shows the status of the
download and installation.
Configure the System
DO
1. Tap on the iPad to begin system configuration. The Crestron Pyng app automatically
connects to the PYNG-HUB.
NOTE: If the Crestron Pyng app does not automatically connect to the PYNG-HUB, enter the
hostname of the PYNG-HUB and tap Connect. The hostname is PYNG-H- and the last eight
digits of the MAC address. The hostname is PYNG-H-7F2ED7CB for a PYNG-HUB with the MAC
address label shown below. The MAC address label is located on the bottom of the PYNG-HUB.
Example of MAC Address
COLOR PART NUM.
White 4520167
White 2043857
2003576
2045865
2007231
LAN PoE:
Power and 10BASE-T /
100BASE-TX Ethernet
from a PoE injector or
switch
Online Store
®
).