Ideon Aviera User Manual page 24

| 24 |
Arm Cap Replacement – with Arm Insert (wood arms only)
1. Turn chair upside down.
2. Remove two #8 x 3"L wood screws on underside of stringer (#2 square
drive for wood arms).
3. Push upholstered arm insert out of the chair from the bottom edge and
remove.
4. Remove plastic caps on the underside of the arm top with a flathead
screwdriver or razor blade.
5. Remove three 10-32 nuts using a 3/8" socket.
6. Remove three 10-32 threaded studs using a 3/32" Allen key.
7. Remove arm cap and replace.
8. Install three 10-32 threaded studs using a 3/32" Allen key.
9. Install three 10-32 washer and nut using a 3/8" socket. Hand-tighten only
(too tight will leave depressions in top side of pad).
10. Reinstall plastic caps over holes.
11. Reinstall upholstered arm insert by aligning tabs in the top side of the arm
with cutouts in the upholstery.
12. Push bottom portion of upholstery into the arm, align with center of arm
stringer.
13. Reinstall two #8 x 3"L wood screws using a #2 square drive.
Seat Replacement
Guest/Patient Chairs
1. To remove the seat, turn the chair over.
2. Remove four #12 Phillips wood screws that hold the seat to the frame from
below the chair that are easily accessible.
3. Replace the seat and re-install the four Phillips wood screws.
Freespan, Pre-Configured or Mulitseating Chairs
1. To remove the seat, turn the chair over.
2. Locate two clips under the front of the seat.
3. Push the clips open and rotate the seat off of the steel rod in back.
4. Reinstall the seat by hooking the back clips under the steel rod. Slip the
seat back over the front tabs and push down.