Corner Round 90° Table - Ideon Aviera User Manual

Corner Round 90° Table
Steps
1. Unpack table and chairs from shipping containers and locate parts.
(See chart at the top of this section for parts list and pictures.)
Always build configurations from left to right as you face it. Corner
90° tables are reversible, meaning that a table may be placed
between seats facing in opposite directions.
2. Turn the table top upside down.
3. Beginning on the left side, place the R bracket at the rear of the table top
and screw two #12 x 5/8" Phillips wood screws through the bracket into
the underside of the table top. Repeat for the front F bracket.
4. On the right side, place the R bracket at the rear of the table top and
screw two #12 x 5/8" Phillips wood screws through the bracket into the
underside of the table top. Repeat for the front F bracket.
5. Screw two 10-32 x 1-½" Phillips machine screws (for wood legs) or two
10-32 x ¾" Phillips machine screws (for metal legs) through the bracket
at one corner of the table and into a table leg [New Round Corner Table
Figure B] Repeat for the second leg.
6. Tilt the left chair back to the floor, Orient the table with legs in back, on the
floor. Use four #12 x 1" Phillips wood screws to screw the front and rear
brackets into the seat support bar.
Install all screws to a loose fit, aligning the table with the chair to
make it sit straight with the arms.
7. Return the connected chair and table to an upright position. Align the right
chair with the table. Use four #12 x 1" Phillips wood screws to screw the
front and rear brackets into the seat support bar.
| 21 |