Ideon Aviera User Manual page 11

FIG. 1
PuSH TO
HOLD CLIPS
OPEn
ROTATE TO
REMOvE SEAT
"START" CHAIR
| 11 |
FIG. 2
FIG. 3
"CEnTER" CHAIR
Steps
1. Unpack the Start, End and all Center elements from shipping
containers and locate hardware.
The hardware bag will either be stapled to the bottom of the
chair or attached to one of the inserts in the box.
2. Begin with the Start element (fig. 1). This piece can be identified
because it is the only element with four legs and two arms.
The following steps show how to attach the Center element (fig. 2).
If more than one Center is specified or multiple seat widths or back
types are involved refer to the space planning layout or the visual
Confirmation to verify seat size and back type.
Build the configuration from left to right (facing the chair)
beginning with the Start section.
3. To connect the Start and Center elements, first remove the seat from
the center element. To remove the seat, turn the chair over. Locate
two tabs under the front of the seat (fig.3). Push the clips open and
rotate the seat off of the steel rod in back. Align the seat support bar
and the back of the Center element with the adjacent Start element.
The support bar runs front to back on the side at the bottom of
the seat.
4. With a 3/16" Allen wrench or hex key install six 5/16 x 3/4" thread
hex bolts into the left side of the Start chair, using the holes
indicated. Install all screws by hand before tightening. Fully tighten
screws with all chair legs on the floor.