Center Table - Ideon Aviera User Manual

Center Table

| 18 |
Steps
1. Unpack table and chairs from shipping containers and locate parts.
(See chart at the top of this section for parts list and pictures.)
Always build configurations from left to right as you face it. Center
tables are reversible, meaning that a table may be placed between
seats facing in opposite directions.
2. Turn the table top upside down.
3. Beginning on the left side, place the R bracket at the rear of the table top
and screw two #12 x 5/8" Phillips wood screws through the bracket into
the underside of the table top. Repeat for the front F bracket.
Reverse the placement of the R and F brackets if the center table is
to be installed between chairs facing opposite directions.
4. On the right side, place the R bracket at the rear of the table top and
screw two #12 x 5/8" Phillips wood screws through the bracket into the
underside of the table top. Repeat for the front F bracket.
5. Tilt the left chair back to the floor and align the table top. Use four
#12 x 1" Phillips wood screws to screw the front and rear brackets into
the seat support bar.
6. Tilt the right chair back to the floor and align the table top. Use four
#12 x 1" Phillips wood screws to screw the front and rear brackets into the
seat support bar.
7. Tighten all screws and return the chairs and connected table to an
upright position.