Corner 45° Table - Ideon Aviera User Manual

Corner 45° Table
Steps
1. Unpack table and chairs from shipping containers and locate parts.
(See chart at the top of this section for parts list and pictures.)
Always build configurations from left to right as you face it. Corner
45° tables are reversible, meaning that a table may be placed
between seats facing in opposite directions.
2. Turn the table top upside down.
3. Beginning on the left side, place the R bracket at the rear of the table top
and screw two #12 x 5/8" Phillips wood screws through the bracket into
the underside of the table top. Repeat for the front F bracket.
4. On the right side, place the R bracket at the rear of the table top and
screw two #12 x 5/8" Phillips wood screws through the bracket into the
underside of the table top. Repeat for the front F bracket.
5. Tilt the left chair back to the floor and align the table top. Use four #12 x
1" Phillips wood screws to screw the front and rear brackets into the seat
support bar.
6. Return the connected chair and table to an upright position. Align the right
chair with the table. Use four #12 x 1" Phillips wood screws to screw the
front and rear brackets into the seat support bar.
7. Tighten all screws to complete the assembly.
| 19 |