End Table - Ideon Aviera User Manual

End Table

Steps
1. Unpack table and chair from shipping containers and locate parts.
(See chart at the top of this section for parts list and pictures.)
Always build configurations from left to right as you face it. End tables
are reversible, meaning that they can be placed at either end of a
configuration.
2. Turn the table top upside down.
3. Place the R bracket at the rear of the table top and screw two #12 x 5/8"
Phillips wood screws through the bracket into the underside of the table
top. Repeat for the front F bracket.
Reverse the placement of the R and F brackets if the end table is to
be installed to the right of the chair.
4. Screw two 10-32 x 1-½" Phillips machine screws (for wood legs) or two
10-32 x ¾" Phillips machine screws (for metal legs) through the bracket at
one corner of the table and into a table leg. Repeat for the second leg.
5. Orient the table with legs opposite the chair. Tilt the chair and table back
to the floor. Use four #12 x 1" Phillips wood screws to screw the front and
rear brackets into the seat support bar.
Install all screws to a loose fit, aligning the table with the chair to
make it sit straight with the arms.
6. Tighten all screws and return the table and connected chairs to an
upright position.
| 17 |