Installation Diagram; Menu System - Wilson Electronics PRO 1100 Installation Manual

Installation
Diagram
A Wilson Lightning Surge Protector is recommended for all building installations. Make
sure the protector is installed outside the building. Connect it to suitable ground and in
line, between the Outside Antenna and the Signal Amplifier.
Outside Directional
Antenna
A Lightning Surge Protector
is recommended for all
building installations.
6
IN-BUILDING CELL SIGNAL AMPLIFIER
Inside Dome
Antenna
Pro 1100
to power
BAND 2 - PCS
20
FULL GAIN
10 64 dB
0
-10
-20
-30
UL DL
Signal
The direction of the
outside antenna should
be adjusted until the "DL"
bar is maximized.
PRO 1100

Menu System

The Pro 1100 takes about 5 seconds to boot up. Once boot up is complete, the home
screen will appear, showing the amplification and status of each port and band.
HOME
Band 2
SW VERSION 4.03r1.28
Full Gain
Band 12
Start Up Screen
(LTE-Lower)
Full Gain
Band Menu Color Description HOME
Band 2
Full Gain
Band 12
(LTE-Lower)
Full Gain
SETTINGS
Band 2
Enabled
Band 12
(LTE-Lower)
SW Version: 4.03r.28
Serial Number: 460047B0123456789
SETTINGS
Band 2
Enabled
Band 12
PRO 1100 IN-BUILDING CELL SIGNAL AMPLIFIER
(LTE-Lower)
SW Version: 4.03r.28
Serial Number: 460047B0123456789
Home Screen
HOME
Band 4 Band 5 Band 2
(PCS) (AWS) (CELL)
Full Gain Full Gain Full Gain
Band 13 Band 12
(LTE-Upper) (LTE-Lower)
Full Gain Full Gain
SETTINGS
SETTINGS
Band 4 Band 5
Band 2
(PCS) (AWS) (CELL)
Disabled Shutdown
A solid green light indicates that a band
Band 13
is operating correctly with maximum Band 12
(LTE-Upper)
(LTE-Lower)
allowable gain.
Full Gain
SETTINGS
SW Version: 4.03r.28
Serial Number: 460047B0123456
A solid yellow light indicates band gain
reduction because of an oscillation
condition. Reposition antennas (increase
HOME
separation between indoor and outdoor
Band 4 Band 5
Band 2
(PCS) (AWS) (CELL)
antennas, and point in opposite directions)
and then reboot (turn the unit off & on)
Disabled Enabled
the Pro 1100 to reactivate the band and
Band 13
Band 12
(LTE-Upper)
(LTE-Lower)
maximize performance. When adequate
Enabled Enabled
HOME
separation is achieved, the yellow lights
will return to green upon reboot.
Note: when the light is yellow, the band
is operational; however, performance
BAND 5 - CELL
is reduced.
Band 4 Band 5
20
(PCS) (AWS) (CELL)
10
Enabled Enabled
7
-10
Band 13
(LTE-Upper) -20
-30
Enabled Enabled
HOME
Band 4
(PCS) (AWS)
Disable
Band 1
(LTE-Upp
Full Gai
Disable Ba
Band 4
(PCS) (AWS)
Are you sure
to disable b
Enabled Enabled
Band 1
(LTE-Upp
YES
Enabled Enabled
Band 4
(PCS) (AWS)
Enabled Disable
Band 1
(LTE-Upp
Enabled Enabled
O
0
Gain
osci
ante
and
Cy
re
UL DL
Signal