Table of Contents
Advertisement
Maintenance manual for technical assistance
- The machine is ready for descaling.
Both buttons on the control panel flash.
Warning
From this stage it is not possible to return to normal
operating mode before completing the descaling
cycle.
Attention
If a power failure occurs, when next switched on the
machine will resume the cycle at which it was inter-
rupted.
- Press the button (1) or (3) to run the descaling cycle.
Note
The estimated time for the descaling cycle is appro-
ximately 14 minutes.
- When the descaling solution in the tank is finished, re-
move and carefully clean the tank.
- Completely fill the tank with fresh drinking (not spar-
kling) water, mount it on the machine again and press
the button (1) or (3) to start the rinse cycle.
Note
The estimated time for the rinse cycle is approxima-
tely 8 minutes.
Warning
The rinse cycle provide the circulation of approxi-
mately 2 litres of water into the hydraulic circuit. The
tank must be filled again with fresh drinking (not
sparkling) water.
Once the descaling cycle is completed, remove the
dummy capsule (A) and the discharge hose (B).
The machine automatically returns to normal operating
mode.
Manual code 10081945 / Rel. 0.00 / February 2014
21
Hide quick links:
Advertisement
Table of Contents
