2.3. Thermostat Installation
2.3.1. Opening and Closing the Thermostat Enclosure
Figure 2-2 - Exploded View of Thermostat
To open the thermostat enclosure, grip the top and the bottom edge of the front part
of the device and pull straight. A certain physical resistance is normal from the
24x contacts pins (terminal strips and terminal blocks) that have to be separated
during the operation.
To close the thermostat enclosure, make sure to align the top and the bottom tabs
between the front part and the baseplate, and then push the front part firmly toward
the wall. Again, some force is required to mate both parts.
NOTE: Both top and bottom securing screws are optional and normally not installed on the
units.
2.3.2. Mounting the Baseplate on the Wall
Figure 2-3 - Baseplate (Back view)
4 • Emerson Programmable Touchscreen Thermostat I&O Manual
026-1739 Rev 0