Keypad and Display Operation Programming
Mode Selection
The Drive has five (5) modes as shown below. The mode can be changed wrth the keys on the keypad panel.
(1) Stop Mode:
(2) Run Mode:
(3) Program Mode
Data Settinq
0
Function Codes in the RUN Mode
It
possible to change during the RUN mode according to the procedure described In (1) above only for
IS
Function Codes F-06 to F-09, F-11 to F-13, F-21 to F-27, F-29, F-35, and F-38 However, it
possible to confirm the data of all Function Codes.
[Keypad operation], FWD and REV signals (Terminal operation)
-
-
-
-
The mode
-
-
- Each time the key
indication of a Function Code and its'data
played, the Function Code number will change By pressing
them while data
- -
- - - - The data
next Functron
mode.
5-2
(Running)
(4) Program Mode
(5) Trip Mode:
0
r
frequency display flashes repeatedly. (61
switched to function settmg mode.
IS
pressed, the display changes between
IS
the data can be changed
IS
memorized and the Function Code advances to the
IS
Code number.
ended and the Drive returns to STOP
IS
IS
IS