Installation - Homematic IP HmIP-BBL-2 Installation Instructions And Operating Manual

Start-up
Installation may only take place in normal com-
mercial switch boxes (device boxes) in accord-
ance with DIN 49073-1.
The device may only be operated with adapters
and an associated, fitted switch cover. The switch
cover may only be removed during configuration.
Please observe the hazard information in section
"2 Hazard information" on page 26 during in-
stallation.
Permitted cable cross sections for connecting to the
blind actuator are:
rigid cable [mm
0.75 – 1.50
7.2

Installation

You can use the blind actuator in a blind, shutter or awning
circuit (see fig. 2). To install the blind actuator, please pro-
ceed as follows:
Step 1
34
2
] flexible cable with/without
ferrule [mm
0.75 – 1.50
Switch off the fuse of the power circuit (see
"6.1 Installation instructions" on page 32).
2
]