Homematic IP HmIP-BBL-2 Installation Instructions And Operating Manual page 30

Hazard information
The actuator is part of the building installation.
The relevant national standards and directives
must be taken into consideration during planning
and set-up. The device has been designed solely
for operation on a 230 V/50 Hz AC supply. Only
qualified electricians (to VDE 0100) are permitted
to carry out work on the 230 V mains. Applicable
accident prevention regulations must be com-
plied with whilst such work is being carried out.
To avoid electric shocks from the device, please
disconnect the mains voltage (trip the miniature
circuit-breaker). Noncompliance with the instal-
lation instructions can cause fire or introduce
other hazards.
When connecting to the device terminals, take
the permissible cables and cable cross sections
into account.
Loads connected to the relay outputs require suf-
ficient insulation.
Please take the technical data (in particular the
maximum permissible switching capacity of the
relay and the type of load to be connected) into
account before connecting a load! Do not exceed
the capacity specified for the device.
28