Table of Contents
Advertisement
Available languages
Available languages
Operation
plied or attached to the device.
•
Please wait until teach-in is completed.
•
If teaching-in was successful, the LED lights up
green. The device is now ready for use.
•
If the LED lights up red, please try again.
•
Complete the setup of your blind actuator by fol-
lowing the instructions in the app.
•
In the app, give the device a name and allocate
it to a room.
8
Operation
After setup, you can perform initial operating functions
via the push-button rocker switch:
•
Short button press upper button: The motor for
the blinds/shutters/awnings moves into the cor-
responding end position.
•
Short button press lower button (opposite direc-
tion): The motor stops.
•
Long button press: The motor is controlled so
that you can adjust the slat position of the blind.
9
Troubleshooting
9.1
Command not confirmed
If at least one receiver does not confirm a command, the
device LED lights up red at the end of the failed trans-
mission process. The failed transmission may be caused
38
Advertisement
Chapters
Table of Contents
