Wake_Up - Fibocom G510 Hardware User Manual

Permanently on

3.10.4WAKE_UP

This pin is used for waking up the module which is in sleep mode, edge trigger. The command ats24=
[value], for example, send a command ats24=2, the module would be in sleep mode after 2s, supposing
that you wake up the module by WAKE_UP pin temporarily, if the module doesn't receive any command
or data in 2s, the module would be in sleep mode as well.
The following figure shows the recommended circuit:
Figure 3- 14 ats24=2, edge trigger, if no data after wake up, set to sleep mode again after 2s
G510 Hardware User Manual
The module is in one of the following status:
• Voice call
Figure 3- 13 Recommended circuit for WAKE_UP
Page 32 of 42