Sony DSR-1500A Operating Instructions Manual page 44

Setting the current tape position as point A or B
44
Playback
Proceed as follows to set the current tape position as point A or B for repeat
playback.
INPUT
dB OVER dB OVER U-BIT SERVO CL REC INHI
0 0 VIDEO AUDIO
V:SDTI COMPOSITE
CH-1 1/2 CH-2 3/4 TC COUNTER NO EDIT
-12 -12 SDTI S VIDEO ANALOG ANALOG
i.LINK Y-R,B AES/EBU AES/EBU
-20 -20 SDI SG SDI SG SDI SG
OUTPUT
-30 -30
-40 -40 VIDEO AUDIO
SDI COMPOSITE CH 1/2 HOURS MINUTES SECONDS
-60 -60 SDTI S VIDEO CH 3/4
PB F S REC MODE VITC
CH- CH-
1 3 2 4 Y-R,B 48K 44.1K 32K 2CH 4CH EDIT MODE
REW PLAY F FWD STOP
While holding down the SET (YES) button in the menu control section, press
the g or G button. The time code value of the current tape position is set as point
A or B, and a message "A set" or "B set" is displayed for 0.5 second in the time
counter display.
Once set, the point A or B time code value is held in the non-volatile memory
of the unit until changed. It is not lost when the unit is powered off.
Note
When setting point A or B, you can only use a time code value. Even when
COUNTER is selected with the COUNTER SELECT button, you cannot use a
CNT value to set point A or B.
To check the point A or B time code value
Press the g or G button in the menu control section. While the button is held
down, the point A or B time code value is displayed on the monitor and in the
time counter display.
If you hold down the g and G buttons simultaneously, the value shown is the
point B time code value minus the point A time code value. If the point A time
code value is greater than the point B time code value, a minus sign ( ) is shown
before the value.
REPEAT
FRAMES
REMOTE
9P i.LINK
REC
Buttons used for setting
the current tape position
as point A
Buttons used for setting
the current tape position
as point B
MENU RESET(NO)
TC
PRESET SET(YES)