Table of Contents
Advertisement
Monitor problems
Symptom
Cause
Data is not
The CHARA. DISPLAY menu item is
superimposed on the
set to OFF.
monitor screen.
The monitor is not connected to the
B Y/CPST (SUPER) connector of this
unit.
The image on the
The 75
monitor screen is too
input on the monitor is in the OFF
bright.
position, or a 75
fitted to its video input connector.
The image on the
In a video signal loop-through
monitor screen is too
connection of video monitors, 75
dark.
termination switches for video input on
monitors other than the loop-end
The image is too dark
monitor are in the ON position.
when recording a
composite video
signal.
Audio problem
Symptom
Cause
The REC/PB LEVEL
The VAR switch on the front panel is
control knobs do not
set to PRESET.
work.
Editing restriction
Symptom
Cause
Execution of video
This phenomenon cannot be avoided with an editing system using this unit as the recorder.
editing in insert mode
erases subcode data
(user bit data, etc.)
recorded on tape other
than time code data.
termination switch for video
terminator is not
Remedy
Set the CHARA. DISPLAY menu item (see page 68) to ON.
Connect the monitor to the B Y/CPST (SUPER) connector.
(You must make this connection to display any type of text on
the monitor.)
Set the 75
termination switch to ON or connect a
terminator.
Set the 75
termination switches to OFF on all monitors
other than the loop-end monitor.
Remedy
Set the VAR switch to REC when recording, or set it to PB
when playing back.
107
Troubleshooting
Hide quick links:
Advertisement
Table of Contents
