Sony DSR-1500A Operating Instructions Manual page 39

To perform the following operations
Operation
Stop recording.
Remove the cassette.
Inhibit the unit from
outputting text information
(time data, operation mode
indications, etc.) to the
video monitor.
Change the time period
before the unit switches
from stop mode to standby
off mode.
Referece level for recording in DV (SP) format
On many consumer DV devices, recording is carried out at a reference level of
12 dB. Threfore, when recording in DV (SP) format on this unit, using the
fixed referenced level of 12 dB is recommended. When dubbing DVCAM
source material recorded at a different reference level, you can carry out manual
adjustment as described in the following.
Player (DSR-1800/1800P/1600
1500A/1500AP)
in E-E mode
Audio input selection: INT SG/1
kHz
REC mode: 2ch or 4ch depending
on DVCAM source
Reference level: Reference level
of the DVCAM source
b)
VAR switch : PRESET
a) On the DSR-1600/1600P, tape recorded at
the reference level is played back.
b) DSR-1500A/1500AP only
Do this:
Press the STOP button.
The unit enters stop mode, and will automatically
switch to standby off mode after the time period set
with the STOP TIMER menu item (see page 71) for
tape protection.
Press the EJECT button.
After a few seconds, the tape is unwound from the
head drum and the cassette is automatically ejected.
If a CNT value is shown on the time counter display
(the time data type indicator "COUNTER" is lit), the
CNT value is reset.
Set the CHARA. DISPLAY menu item (see page 68)
to OFF.
Change the setting of the STOP TIMER menu item
(see page 71) .
a) a)
/1600P / Recorder (DSR-1500A/
1500AP)
in E-E mode
REC FORMAT: DV (SP)
i.LINK/
VAR switch: REC
SDTI (QSDI)/
SDI
For each channel, observing
the audio level meter, adjust
the audio level to 12 dB
with the level control knob.
39
Recording