Table of Contents
Advertisement
Cuing Up to Any Desired Position Set as Point A or B
13
Press the SET (YES) button to confirm the defined value.
The message "NOW SAVING..." is displayed on the monitor screen and
"Saving..." is shown in the time counter display while the new setting is
being saved in memory.
Caution
The new setting may be lost if you power off the unit during the saving
operation. Wait until the saving operation is completed before powering the
unit off.
If you want to discard the changed value
Press the MENU button instead of pressing the SET (YES) button to return
to the menu display, then press the MENU button again to end the menu
operation without saving the changed value into memory.
After the saving operation is completed, the monitor screen and time
counter display return to the REPEAT FUNCTION setting display as
shown in step 9.
14
To set point B, refer to steps 5 to 13. (Select "REPEAT END" in step 5, "B
POINT" in step 7, and "B PRESET" in step 9.)
15
Press the MENU button to close the menu.
You can set any desired tape position as point A or B and cue up to the set point
when required. To cue up to point A or B, holding down the g or G button in
the menu control section, press the REW button in the tape transport control
section.
For the methods of setting points A and B, see the previous section.
49
Playback
Hide quick links:
Advertisement
Table of Contents
