Table of Contents
Advertisement
4. Programming
19-14 Motor/encoder gear nominator
Range:
1
4
19-15 Motor/encoder gear denominator
Range:
1
19-16 Maximum jog velocity
Range:
100
ERPM
19-17 Jog ramp time
Range:
5,000
ms
19-18 Jogl Velocity Scaling
Range:
0
19-19 FFVEL auto-calculation
Option:
[0]
[1]
22
[1...1,000]
[1...1,000]
[1...999,999 ERPM]
NB!
This setting must never exceed a value that is approx. 5% lower than the value in
par. 32-80.
[50...100,000 ms]
[0...1]
*
Disabled
FFVEL enabled
MG.33.R1.02 - VLT
Function:
If the encoder is mounted on a gear where 5 revolutions of the
motor correspond to 2 revolutions of the encoder, GEAR NUM
should be set to "5" (the number of motor revolutions) and
GEAR DEN should be set to "2" (the number of encoder revo-
lutions). If the encoder is mounted directly on the motor shaft
this parameter setting should remain at "1".
Function:
See the description of GEAR NUM. If the encoder is mounted
directly on the motor shaft this parameter setting should remain
at "1".
Function:
The maximum speed allowed while jogging the application is
specified in terms of Encoder Revolutions Per Minute (ERPM).
Function:
This parameter specifies both the ramp-up time as well as the
ramp-down time used during jogging. The ramp time is defined
as the time in milliseconds it would take to ramp from standstill
to the maximum allowed velocity 3280.
Function:
If 1, the scale velocity will be scaled by MOT ENC GEAR NUM/
DEN
Function:
Setting this parameter to "1" will prompt the program to calcu-
late the optimal setting of parameter velocity feed forward.
®
is a registered Danfoss trademark
MCO351 Positioning Controller
Advertisement
Table of Contents
