Operation
Programming with the programming module is to be performed in the same
way as with the buttons..The external and internal buttons correspond to each
other in the following way:
Int. button Ext. button
P
P
∧
+
∨
-
→
→
|
|
26
Meaning
Display mode:
Switch over to programming mode
(Press the button longer than 2 seconds)
Programming mode:
Set the decimal point.
Display mode:
Switch over to the next higher level.
Programming mode:
- Increase the decimal by 1.
- Scroll in the list.
(Value identified with "L")
Display mode:
Switch over to the next lower level.
Programming mode:
- Decrease the decimal by 1.
- Scroll in the list.
(Value identified with "L")
Display mode:
Short-time view of the coordinate (e.g. A01)
Programming mode:
Go to the right by one decimal place (if the last
decimal has been reached: Quit programming
mode).
Operating Instructions for the TERZ 94 Electronic Turbine Meter