First Power Up - Honeywell Accenta Series Engineer's Manual

Accenta/Optima Engineer's Manual

First Power Up

NOTE: For Optima compact, fit the top cover on to the base and connect the speaker wires.
1 Check that the factory fitted links are connected to terminals PA, TAMP and T-A.
2 Fit the battery wires to the battery terminals (BATT).
3 On connecting the battery, the system will go into an alarm condition with an audible alarm indication.
After entry of a valid user code, there is a Tamper indication.
4 Fit the cover to hold down the tamper spring at the bottom centre of the board.
LCD INDICATIONS
Loop Tamper Loop Tamper Loop Tamper Loop Tamper Loop Tamper
5. Enter the user code, press [0][1][2][3] factory set code. The alarm condition will cease and the
system will go into day mode:
NOTE: The LCD keypad will show SYSTEM UNSET
for 30 seconds first.
S u n d a y S u n d a y
S u n d a y S u n d a y S u n d a y
02:36 02:36 02:36
02:36 02:36
6. Immediately enter the engineer code by pressing [PROG][9][9][9][9]
7. The system is now in Engineer program mode and can be programmed.
0>Walk Test 0>Walk Test 0>Walk Test 0>Walk Test 0>Walk Test
Panel
F1
1.6A
(red)
+
-
Black
12V battery
Figure 15. Battery Connection
0 1 - J a n 0 1 - J a n
0 1 - J a n 0 1 - J a n 0 1 - J a n
First Power Up
Board
J4
+ -
AC
BATT
E
L
125mA Fuse
Transformer
LED INDICATIONS
15
Tamper
Day
Attack/PA