Honeywell Accenta Series Engineer's Manual page 48

Operating System (cont'd)
Engineer Reset - LCD Keypad:
After a tamper an engineer reset is required if the Engineer Reset flag is enabled.
• Enter your user code [0123] default. If the system has to be set
by an engineer the message Engineer Restore Required is
displayed.
• Enter your 4-digit engineer code (9999 default).
• The system resets and goes into day mode.
Engineer Reset - LED Keypad:
After a tamper an engineer reset is required if the Engineer Reset flag is enabled.
• Enter your user code [0123] default. When System is
in Tamper the appropriate LED will be flashing.
NOTE: Only the first event will cause the LED to flash.
Subsequent events will have a steady ON condition.
• Enter your 4-digit engineer code (9999 default). The
Tamper LED goes OFF and the system resets
• The system is in day mode. The Day LED is on.
Accenta/Optima Engineer's Manual
Engineer Engineer Engineer Engineer Engineer
Required Required Required
Required Required
C o n t a c t C o n t a c t C o n t a c t
C o n t a c t C o n t a c t
Engineer Engineer Engineer Engineer Engineer
Restored by Restored by Restored by Restored by Restored by
Engineer Engineer
Engineer Engineer Engineer
S u n d a y S u n d a y S u n d a y S u n d a y S u n d a y
44
[user code]
Restore Restore Restore Restore Restore
[engineer code]
0 1 - J a n 0 1 - J a n 0 1 - J a n 0 1 - J a n 0 1 - J a n
10:30 10:30 10:30
10:30 10:30
[user code]
Day Power
TA PA
[engineer code]
Day Power
TA
PA