HP Pavilion x360 14 Series Maintenance And Service Manual page 50

3. Grasp the edge of the memory module (2), and then gently pull the module out of the slot. Use the same
procedure to remove both memory modules.
CAUTION:
not touch the components on the memory module.
To protect a memory module after removal, place it in an electrostatic-safe container.
Install the memory modules:
IMPORTANT:
not touch the components on the memory module. Do not bend the memory module.
1. Align the notched edge of the memory module with the tab in the memory module slot (1).
2. Press the module into the slot until seated (2).
3. Gently press down on the module edges until the side retention clips snap into place (3). Use the same
procedure to install both memory modules.
To replace the memory cover, insert the edges of the cover into the clips on the system board.
42 Chapter 5 Removal and replacement procedures for authorized service provider parts
To prevent damage to the memory module, hold the memory module by the edges only. Do
To prevent damage to the memory module, hold the memory module by the edges only. Do