Table of Contents
Advertisement
Rewriting ClipLink Log Data
You can rewrite the reel number, Mark IN/OUT points
and OK/NG status included in the ClipLink log data.
Changing the Reel Number
To change the reel number of the data item selected on
the ClipLink log data list, proceed as follows.
1
Using the jog/shuttle dial, move the selection mark
(asterisk) to the desired data item on the ClipLink
log data list.
2
Hold down the STOP button and press the SET
button.
The following setting screen appears.
CLIPLINK LOG DATA LIST
(003/196)
*REEL NO
REEL NO
3
Turn the jog/shuttle dial to select the digit to
change.
Rotating the jog/shuttle dial clockwise moves the
current digit position to the right, and
counterclockwise moves it to the left.
4
Hold down the search button and turn the jog/
shuttle dial to change the digit indicated by an
arrow (µ).
94
Chapter 6 ClipLink Operation
SET
2,6
STOP
STANDBY
p
SHUTTLE JOG
4
1,3,4
(XXXXXXXX)
(YYYYYYYY)
5
Repeat steps 3 and 4 until the settings for all digits
are complete.
6
When all digits have been set, hold down the
ENTRY/SHIFT button and press the TRIM+/
MARK button.
The reel number changes.
7
Hold down the STOP button and press the SET
button.
This returns to the original ClipLink log data list.
Note
If you carry out step 7 skipping step 6, the original
ClipLink log data list appears again on the monitor
and, in this case, the reel number is not rewritten.
Changing Mark IN/OUT Points
To change Mark IN/OUT points selected on the
ClipLink log data list, perform the following
procedure.
When Mark IN/OUT points are rewritten to the
cassette memory, the frame digits of the address data
are processed as follows.
For Mark IN point: Any frame-digits value is
counted as 1 second.
For Mark OUT point: Any frame-digits value is
ignored.
2,7
8
–
+
TRIM
CLIP
LIST
MARK
LINK
ENTRY SHIFT
2,4,6
IN
OUT
7,8
4
6
PLAY
3,5
1,3,5
Hide quick links:
Advertisement
Table of Contents
