Two-Unit Synchronous Playback - Sony DSR-70 Operating Instructions Manual

Two-Unit Synchronous Playback

Connecting two DSR-70/70P units and synchronizing
their tape transport, you can carry out two-unit
synchronous playback with an accuracy of ±0 frame.
For equipment/signal connections and basic settings, see the
section "Connections for Two-Unit Synchronous Playback"
on page 122.
AUDIO IN
–
TRIM
CLIP
LIST MARK
LINK
DELETE ENTRY SHIFT
IN
PREVIEW AUTO EDIT
1
Insert two source tapes in the recorder and player.
2
Cue up to the tape position where to start playback
on each of the recorder and the player, then,
holding down the ENTRY/SHIFT button, press the
IN button.
On each unit, the cued-up tape position is set as the
IN point and the IN button lights.
3
Press the RECORDER button, lighting the
RECORDER indicator.
+
3
4
2
OUT
REVIEW
Perform the following procedure.
(In the following, the controlling unit is referred to as
the recorder and the controlled unit as the player.).
REC INHI TC CHARACTER
OFF LOCAL INT ON MENU SET
ON REMOTE EXT OFF
ASSEMBLE INSERT
VIDEO AUDIO TC EJECT
6
CH1,1/2 CH2,3/4
AUDIO IN
– +
TRIM
PLAYER RECORDER
CLIP
LIST MARK
LINK
DELETE ENTRY SHIFT
IN OUT
PREVIEW AUTO EDIT REVIEW
2
4
On the recorder, holding down the ENTRY/SHIFT
button, press the PREVIEW button.
Both the recorder and the player start preroll
followed by playback by the two units.
When the setup menu item 004 is set to ON and
305 set to ACCUR on the recorder side, the
recorder and player tape transports are
synchronized during the preroll allowing two-unit
synchronous playback with ±0 frame accuracy to
start at the player and recorder IN points.
To end synchronous playback while it is in
progress
Press the STOP button on the recorder.
Chapter 5 Special Editing and Recording/Playback
REC
PREROLL REC SEQ EDIT
METER
INHI
CH-1/2
r
CH-3/4
REW SERVO PLAY F FWD STANDBY STOP
0 ) p
SHUTTLE JOG
REVERSE FORWARD
89