Table of Contents
Advertisement
Power Preparations
Using the BP-L60(A)/L90(A) Battery Pack
To attach the battery pack
30
Chapter 2 Power Preparations and Connections
Notes about battery usage
• Before using the batteries, be sure to charge them fully with the special
battery charger. Refer to the operating instructions of your battery charger
for more information about how to charge the batteries.
• Batteries may not be completely charged if you charge them immediately
after use when they are still warm. You should wait until the batteries
cool before charging them.
This unit can be operated for about 120 minutes at normal temperature on
fully charged BP-L90 Battery Pack. (When no optional board is installed.)
To charge the battery pack
Before use, charge the battery pack with the BC-L100/L100CE Battery
Charger. It takes about 2.5 hours to charge the BP-L60(A) and about 3.5
hours to charge the BP-L90(A).
For more information about how to charge the battery pack, refer to the manual
for the BC-L100/L100CE.
Attach the BP-L60(A)/L90(A) as shown in the following figure. Before
attaching, remove the cover of the battery connector.
Remove the cover in the same way that you remove the battery pack. For details
see the next section "To remove the battery pack".
1
Align the groove on the top panel of
the BP-L60(A)/L90(A) with the
guides.
2
Slide the BP-L60(A)/L90(A) in so
that its connector is firmly
connected to the unit's battery
connector.
Hide quick links:
Advertisement
Table of Contents
