Sony DSR-70 Operating Instructions Manual page 108

Extended Menu
Item number Item name
308 SELECTION OF
STD/NON-STD
FOR ANALOG
VIDEO IN
317 AUDIO EDIT
MODE
318 EDIT RETRY
327 AUDIO MODE
CHANGE
Item number Item name
401 FUNCTION MODE
AFTER CUE-UP
403 AUTOMATIC
PREROLL
REFERENCE
ENTRY
Item number Item name
501 STILL TIMER
502 TAPE
PROTECTION
MODE FROM
SEARCH
108
Chapter 7 Setup Menu
Menu items in the 300s, relating to editing operations (continued)
Settings
Select the STD or NON-STD mode in accordance with a composite video or S-video
input.
STD: The STD mode is always used (forced STD mode).
N-STD: Use this setting when the input video signal is unstable (forced NON-STD
mode).
When using a VCR with no built-in time base corrector (e.g. a home-use VHS-system
VCR), select N-STD.
Specify the type of editing for audio signals.
CUT: Cut editing (discontinuity in audio signal may result at the editing point, causing
noise.)
FADE: Fade out and fade in
When editing with two DSR-70/70P units, set for the recorder. Selects the operation if
the recorder was not synchronized in time.
OFF: Editing is not carried out, and the unit stops.
ON: The editing is automatically retried (up to twice).
Select whether to allow audio data recorded on tape in two-channel mode (or four-
channel) to be re-recorded in four-channel (or two-channel mode).
OFF: Do not allow re-recording in a different audio mode.
ON: Allow re-recording in a different audio mode.
Menu items in the 400s, relating to preroll
Settings
Select the state that the unit goes into after a cuing-up operation.
STOP: Stops (the STOP mode).
STILL: Still playback (in search mode).
Select whether or not the edit IN point is automatically set by pressing the PREROLL
button when the IN point is not set before starting preroll.
DIS: IN point is not set automatically.
ENA: I N point is set automatically.
Menu items in the 500s, relating to tape protection
Settings
Select the time delay from the tape transport stopping (either the "STOP" mode" or the
still playback mode in search mode) until the unit automatically switches to the tape
protection mode, in order to protect the rotary heads and the tape.
0.5S... 8M ...30M: Set the value in the range 0.5 seconds to 30 minutes.
Select the operation of the protection mode to protect the rotary heads and tape when in
the still playback mode in search (jog/shuttle) mode.
STEP: Step forward at
STDBY: Switch to Standby OFF mode (the unit not on standby).
IN
1 / normal speed every 2 seconds.
30
OUT