Setting The Adjusting Sheet - DURKOPP ADLER 540-100-1 Manual Complete

6.3 Setting the adjusting sheet

22
Standard reference position of the needle bar:
–
Switch the machine on and let it move to the initial position.
–
Switch the machine off again.
Correction:
–
Loosen the screws 8 and shift the proximity switch 6 according to
the instructions.
–
Tighten the screws again.
–
Readjust the adjusting sheet, if required. Chapter 6.3 Setting the
adjusting sheet.
The adjusting sheet is used for the quick positioning of the needle bar
in the adjustment positions when the machine is switched off.
–
Needle bar in the centre of the needle hole (reference position)
Bolt 10 abuts on the right flank of the slotted hole.
–
Needle bar in the furthest right entry point with a throw width of 6 mm.
Bolt 10 abuts on the left flank of the slotted hole.
11
–
Let the machine move to the initial position (e.g. immediately after
switching on).
–
Loosen the screws 11.
–
Shift the sheet in such a way that the right flank of the slotted hole
of the sheet abuts on bolt 10 of the needle bar linkage.
–
Tighten the screws 11 again.
Note
Before adjusting the sheet the settings described in chapter 6.2 must
have been made correctly.
8
6
9