Altering Parameter Values; Numerical Values; Selection Of A Parameter - DURKOPP ADLER 540-100-1 Manual Complete

1.1 Altering parameter values

1.1.1

Numerical values

1.1.2

Selection of a parameter

4
Numerical values can be altered as follows:
Select the line with the value to be altered with the cursor keys ñ
–
and ò.
–
Actuate the OK key.
The cursor flashes under a digit of the numerical value.
Change between the digits with the cursor keys ï and ð.
–
–
Increase or reduce the value of the selected digit with the cursor
keys ñ and ò.
In case of parameters which cannot optionally be altered another
possible parameter value is indicated by actuating the cursor keys
ñ and ò.
–
Actuate the OK key.
The set value is taken over.
–
If the set value is not to be taken over, actuate the ESC key.
The initially set value is restored
Some parameters allow to choose between several possibilities.
The parameter can be altered as follows:
Select the line with the value to be altered with the cursor keys ñ
–
and ò.
–
Actuate the OK key.
Change between the possibilities with the cursor keys ñ and ò.
–
The selected parameter is displayed.
–
Actuate the OK key. The set parameter or value is taken over.
–
If the set parameter or value is not to be taken over, actuate the
ESC key.
The initially set parameter or value is restored.