Setting The Working Height; Setting Up The Machine Head; Lengthwise Installation; Widthwise Installation - DURKOPP ADLER 540-100-1 Manual Complete

5.4 Setting the working height

5.5 Setting up the machine head

5.5.1

Lengthwise installation

5.5.2

Widthwise installation

The working height is adjustable.
–
Loosen both screws 5 on each of the frame bars.
–
Set the desired working height. Ensure that if possible both sides
are pulled out or pushed in evenly.
–
Tighten both screws 5 again.
5
When taking the machine head out of the transport box, do not grab
hold of the blocks, the cloth press plate or the control panel. Make sure
that the oil reservoir is taped up to prevent that oil escapes during the
set up.
The machine head can be mounted lengthwise or widthwise. A swivel
device is optionally available allowing lengthwise or widthwise
installation to be changed quickly.
Fig. 1
–
Place the machine head on the table plate according to figure 1.
–
Feed all cables and hoses through the bore hole in the table top.
–
Set the machine head and screw it to the table top, according to
figure 2, using 4 hexagonal screws .
Fig. 2
–
Place the machine head on the table plate according to figure 1.
–
Feed all cables and hoses through the bore hole in the table top.
–
Set the machine head and screw it to the table plate, according to
figure 3, using 4 hexagonal screws .
Fig. 3
2
11