Dexibell VIVO S9 Owner's Manual page 69

Main, Coupled, Lower, Pedal
Parameter Setting Explanation
Allows you to assign a MIDI receive
Channel 1 ~ 16
channel to the selected part.
This parameter allows you to transpose
the received note messages before
-48~0~+48
sending them to the S9's tone generator.
Shift
The maximum possible transposition
Default : 0
is four octaves up (48) and down (–48).
Each step represents a semi-tone.
Modulation
Volume
Panpot
Expression
Aftertouch
These filters allow you to specify
OFF, ON
Reverb
whether (On) or note (Off ) the messages
Default: On
Hold
in question should be received.
Sostenuto
Soft
PG (Program
Change)
PB (Pitch Bender)
Part MIDI RX channel (default)
Main 1
Coupled 2
Lower 3
Pedal 4
Memory 15
Organ control 14
2.
If you selected the "Memory" part, the following page is showed:
Memory
Parameter Setting Explanation
OFF, ON
Select "On" if you want to receive MIDI
Status
messages for the memories selection.
Default: On
1 ~ 16
Allows you to assign a MIDI receive
Channel
channel to the "Memory" part.
default: 15
3.
If you selected the "Organ Control" part, the following page is showed:
Memory
Parameter Setting Explanation
Select "On" if you want to receive
draw-faders MIDI messages. For details
OFF, ON
Status regarding the MIDI messages received,
Default: On
see "Draw-faders MIDI Controls" (p.
76).
1 ~ 16
Allows you to assign a MIDI receive
Channel
channel to the "Organ control" part.
default: 14
 TRANSMISSION
You can configure the MIDI transmission parameters of Main,
Coupled, Lower and Pedal part. Additionally, you can manage the
transmitted MIDI messages for the memories and Organ control. By
the "COMMON" section, you can decide whether to send or not the
"Active Sensing" MIDI messages.
1.
Select the part you want to edit (Main, Coupled, Lower and Pedal).
In the example above we selected the Main part.
Main, Coupled, Lower
Parameter Setting
OFF, ON
Status
Default: On
1 ~ 16
Channel
Default: 1
-48~0~+48
Shift
Default : 0
OFF, ON
Local
Default: On
Modulation
Volume
Panpot
Expression
Aftertouch
OFF, ON
Reverb
Default: On
Hold
Sostenuto
Soft
PG (Program
Change)
PB (Pitch Bender)
2.
If you selected the "Memory" part, the following page is showed:
Parameter Setting
OFF, ON
Status
Default: On
MIDI
Explanation
Select "On" if you want the selected part
to transmit MIDI data.
Allows you to assign a MIDI transmit
channel to the selected part.
This parameter allows you to transpose
the note messages before they are
transmitted to an external MIDI device.
The maximum possible transposition is
four octaves up (48) or down (–48).
You can disconnect the part from
the internal sound source ("Off") – or
re-establish that connection ("On").
These filters allow you to specify
whether (On) or note (Off ) the messages
in question should be transmitted.
Memory
Explanation
Select "On" if you want to transmit MIDI
messages when you recall a memory.
See "Working with the Memories" (p.
47).
69