Dexibell VIVO S9 Owner's Manual page 16

Managing the Song Library
The S9 give you the possibility to install new
sounds and manage existing ones.
1.
Press the [SONG LIBRARY] button to access the Sound
Libraries enviroment.
Record and Playback a Song
1.
Press the [! ] button to start recording.
2.
Play your song.
3.
Press the [! ] button to stop recording.
4.
Press the [*-,] button to listen your recording.
5.
Press the [*-,] button again to pause the song.
Change the Keyboard Octave
The Octave function allows you to change the
pitch of the selected part in octave steps.
1.
Press the [OCTAVE] button.
T2L Editor
1.
Press this button to open the T2L page
and personalize the sounds of the
instrument.
Function Buttons
1.
Press these buttons to select
functions/options shows at the
bottom of the display.
16
Transposing the Keyboard
1.
Press the [TRANSPOSE] button to calls up the page where you
can change the transposition value.
2.
Use the [DATA ENTRY] knob or the[] [] buttons to change
the value.
CHORD ENHANCER and CHORD FREEZE
[CHORD ENHANCER]
This function improves the sound of the adding notes to the
played chord. The Chord Enhancer function works when a not
percussive tone is selected. See the Orchestral Sound List.
1.
Select a not percussive sound. See the sounds table "S9 Orchestral Tones List"
(p. 75).
2.
Press the CHORD [ENHANCER] to activate the function (its indicator lights).
3.
Play a chord on the keyboard.
The Chord Enhancer function adds notes to the chord you played.
[CHORD FREEZE]
The Chord Freeze allows you to memorize a complex chord and
play it in different tonality on the keyboard using a finger only.
1.
Playing and holding the chord (at least two notes) on the keyboard that you
want "Freeze", press the CHORD [FREEZE] button. Its indicator lights.
2.
Play a note on the keyboard with the desired tonality.
The chord previously memorized is reproduced with the same
tonality of the played note.
Song Mode
1.
Press the [SONG] button to enter in SONG mode (Its
indicator lights).
2.
Press the "SONG LIST" F2 function button.
The display shows the contents of the Song
internal memory.
Managing the Aftertouch
This function that lets you modify the sound by
applying additional pressure to the key.
1.
Press the [AFTERTOUCH] button to enable the Aftertouch
function. Its indicator lights.
2.
Press and hold the [AFTERTOUCH] button to open the
Aftertouch page to edit the parameters.
Menu/Exit button
1.
Data Entry/Song Volume
When a parameter is selected this
knob works as Data Entry. When the
instrument is in song mode, this knob
allows you to set the volume of the song
player.
Quick Guide
Press this button to open and close the
menu page where you can view and select
all available functions.