Special Pedalboard Tones: "Pedal Bass" And "Pedal Doublbs; Play All Parts In Layer Mode; How To Change The Split Point; Adjust The Volume And Reverb For Each Part By The Draw Faders - Dexibell VIVO S9 Owner's Manual

Tones" (p. 24)
.
3.
Play the keyboard.
Turn the VOLUME knob to adjust the volume.
MEMO
The default split point is set between keys F3 and F#3. To change
the split point see "How to change the Split Point" (p. 26).
4.
To adjust the volume for the Main and Pedal keyboard
part see "Adjust the Volume and Reverb for Each Part by
the Draw Faders" (p. 26).
Special Pedalboard Tones: "Pedal Bass" and
"Pedal DoublBs".
In the sounds set of the S9 there are two special sounds that came
in handy when you playbass note in rapid succession like jazz. The
"Pedal Bass" and "Pedal DoublBs" sounds was sampled with a little
bit sustain. In this way, lengthening the release of the sound, allows
the organist to play the "walking" bass line.

Play All Parts in Layer Mode

The S9 give you the possibility to play the Lower and Pedal in layer
with the Main and the Coupled part. To do this you need to set a
parameter in off, this parameter is called "Split"
1.
Press and hold the [LOWER] or the [PEDAL] button until
the display shown the following page.
2.
Use the [] [] buttons to select the "Split" parameter.
3.
Use the [DATA ENTRY] knob or the
the "Split" parameter to OFF.
Parameter Setting
OFF, ON
Split
Default: ON
Now all parts will play in layer.
MEMO
To play the keyboard in split mode set again the "SPLIT"
parameter to "ON".
26
[ ] buttons to set
[]


How to change the Split Point

1.
Press and hold the [LOWER] or the [PEDAL] button until
the display shown the following page.
2.
Use the [] [] buttons to select the "Split Point"
parameter.
3.
Use the [DATA ENTRY] knob or the
change the split point value.
Parameter Setting
F1 ~ E7
Split Point
Default: F3
MEMO
The "Split Point" parameter works when the keyboard is in split
mode (Lower or Pedal part is selected) and the "Split" parameter
is set to "ON" (default).
Adjust the Volume and Reverb for Each
Part by the Draw Faders
By the draw faders you can adjust the volume for each part.
1.
Press [MIXER] button to assign the 9 draw faders to adjust
the volume or/and reverb for each part.
2.
You can adjust the volume for each part moving the
corresponding draw faders. On the panel, below each one
of draw fader, is indicated the assigned part.
3.
You can adjust the reverb for each part moving the
corresponding draw faders. On the panel, below each one
of draw fader, is indicated the assigned part.
Selecting Tones
[ ] buttons to
[]
