insys icom 56k Manual page 74

AT Command Reference
Command
AT\B<n>
AT%B<n>
AT%B0
AT%B1
AT%C<n>
74
Description
Send "break" to the other INSYS Modem 56k AC/DC 4.2
For connections that were not error corrected the INSYS Modem 56k AC/DC 4.2
sends a break signal to the other INSYS Modem 56k AC/DC 4.2. The length of the
signal is: the specified parameter times 1/10 of a second.
For error corrected connections, the INSYS Modem 56k AC/DC 4.2 sends a break
signal according to the active error correction protocol without considering a pa-
rameter specification.
If no connection is established or if a fax connection is active, an error message is
displayed.
AT\B1
1/10 second break signal
AT\B2
2/10 second break signal
AT\B3
3/10 second break signal
AT\B4
4/10 second break signal
AT\B5
5/10 second break signal
AT\B6
6/10 second break signal
AT\B7
7/10 second break signal
AT\B8
8/10 second break signal
AT\B9
9/10 second break signal
Switch key abort on and off during connection
Key abort is active. Each character on the TX line will result in an
interruption of the connection setup (default)
Key abort is deactivated. A connection setup can not be interrupt-
ed manually. A connection setup can only be terminated via DTR
drop, internal canceling of the INSYS Modem 56k AC/DC 4.2 (NO
DIALTONE, BUSY) or Timeout (NO CARRIER). (S-Registry 36 Bit 6)
Enable data compression
Enable/disable a data compression type
The INSYS Modem 56k AC/DC 4.2 can only perform data compression for error
corrected connections.
AT%C0
No data compression enabled
AT%C1
MNP 5 data compression enabled
AT%C2
Enable V.42bis and V.44 data compression
AT%C3
Enable MNP 5 and V.42bis data compression (default)
INSYS Modem 56k AC/DC 4.2