insys icom 56k Manual page 40

Functions
In order to explicitly use pulse
dialling for dialling the number, use
the command
If the remote terminal accepts the
connection, the INSYS Modem 56k
AC/DC 4.2 indicates
If the remote terminal is busy, the
INSYS Modem 56k AC/DC 4.2
indicates
If the remote terminal is no
modem, the INSYS Modem 56k
AC/DC 4.2 indicates after the
remote terminal has picked up
If the INSYS Modem 56k AC/DC
4.2 does not receive a dial tone
after picking up before dialling, it
indicates
If the INSYS Modem 56k AC/DC
4.2 is connected to a telephone
system, it may be possible that no
dial tone, but a different acoustical
signal is audible after picking up.
To configure the INSYS Modem
56k AC/DC 4.2 that it does not wait
for a dial tone before dialling, use
the following command before
dialling
In order to change to command
mode during a data connection,
use the escape sequence
No data must be transmitted for 1
second that the INSYS Modem 56k
AC/DC 4.2 changes to command
mode.
In order to change from command
mode to normal data transmission
again, use the command
In order to accept an incoming
connection, use the command
40
INSYS Modem 56k AC/DC 4.2
ATDP<number>
CONNECT
BUSY
NO CARRIER
NO DIALTONE
ATX3
+++
ATO
ATA