insys icom 56k Manual page 54

Functions
In order to define the type of the message
dispatch (SMS to mobile phone, SMS to
fixed network, data connection, fax (see
Table 13: Message transmission type), use
the command
If you want to send all messages to mobile
phones, e.g. in the Vodafone network, use
the command
The connection type depends on the type of transmission, the provider
and the end terminal. Please note that you set the transmission type for
all messages of the INSYS Modem 56k AC/DC 4.2. If you set SMS to
mobile phone via D2, for example, you can only send SMS to mobile
phones in the Vodafone network.
Some providers support the forwarding of a message to an e-mail
address. Please contact your provider for further information. The
following table shows various pre-settings of the INSYS Modem 56k
AC/DC 4.2 to send messages to different terminal devices.
In order to send an alarm via SMS, you must specify a service center
number. This number can be requested from the respective providers. A
selection of providers can also be found in the "SMS Provider / Service
Center" section.
Transmission
Data connection
SMS to Mobile
SMS to Mobile
SMS to Mobile
SMS to Mobile
Fax
SMS to mobile phone or
fixed network
Table 13: Message transmission type
This setting must be saved.
Enter the message for the simple alarming
(max. 159 characters) with this command:
After this command is entered, the modem
will respond and wait for the message text.
54
Protocol Data format
PET 8N1
UCP 7E1
PET 7E1
UCP 8N1
ETSI
INSYS Modem 56k AC/DC 4.2
AT*M<n>
AT*M4
Example
T-Mobile, O2 or E-Plus network
Vodafone network
AT&W
AT*V
New alarm text:
AT*M0
AT*M1
AT*M2
AT*M3
AT*M4
AT*M5
AT*M6