Switching The Outputs / Querying The Inputs Via Dtmf - insys icom GSM 4.3 Manual

Functions

12.21 Switching the Outputs / Querying the Inputs via DTMF

This section describes how the outputs of the INSYS GSM 4.3 can be
switched or pulsed with the help of the DTMF tones of a conventional tele-
phone. The INSYS GSM 4.3 responds with a tone.
Acoustic responses of the INSYS GSM 4.3:
OK =short low tone, short high tone
ERROR
Input ACTIVE
Input INACTIVE = medium long low tone
The following commands (keys) are defined:
Login at the INSYS GSM 4.3 with a remote phone

The DTMF mode at the INSYS GSM 4.3 is enabled.

The selective call acceptance is deactivated or allows calls from the exten-
sion of the phone which you use to switch the outputs.

The acoustic "OK" is a short low tone, followed by a short high tone.

The acoustic "ERROR" is a long low tone.
2. Call the INSYS GSM 4.3.

The INSYS GSM 4.3 will accept the call after a configured number of
ring tones.

The INSYS GSM 4.3 sends an acoustic "OK".

The INSYS GSM
3. Enter the DTMF PIN.

You will hear the acoustic signal for "OK" again.
70
=long low tone
= medium long high tone
terminate connection
0*
switch output 1 to NO
1*1
switch output 1 to NC
1*0
1#*<x> pulse output 1 (<x> = number of pulses)
switch output 2 to NO
2*1
switch output 2 to NC
2*0
2#*<x> pulse output 2 (<x> = number of pulses)
request alarm inputs
3*
4.3 will now expect that the PIN is entered.
INSYS GSM 4.3