Mitsubishi Electric MELSEC-A series User Manual page 84

Error
Error
Code
Message
(D9008)
"SP. UNIT 46
ERROR"
"LINK 47
PARA.
ERROR"
Table 6.1 Error Code List (Continue)
Detailed
Error CPU
Code States
(D9092)
— Stop or (1)Access (execution of
Continue
(set by
para-
meter)
462 (1)There is inconsistency in
(2)The location designated
— Continue (1)There is inconsistency for
(2)The total number of sta-
Error and Cause
or instruction)
FROM TO
has been made to a loca-
tion where no special
function module is
installed.
the module name
between the special
instruction for CC-Link
and I/O assignment of the
parameter.
by the special instruction
for CC-Link is not the
master module.
some reason between the
data, which is written by
the peripheral device in
the parameter area of the
link under link range des-
ignation using parameter
setup, and the link param-
eter data read by the CPU
module.
tions is set at "0."
70
Corrective Action
(1)Use the peripheral device
to read and correct the
and/or instruc-
FROM TO
tion at the error step.
(1)Correct the module name
of I/O assignment of the
parameter to that of the
special instruction for CC-
Link.
(2)Use the peripheral device
to check and correct the
special instruction for CC-
Link at the error step.
(1)Write parameters and
check again.
(2)If the error persists, there
is a fault in hardware. Con-
sult Mitsubishi representa-
tive.