Table of Contents
Advertisement
Programming
56
5.2.4.3
EQUIPM.-CONFIG
WATERSEN_IN ? 1/0
EQUIPM.-CONFIG
WATERSEN_EX ? 1/0
5.2.4.4
EQUIPM.-CONFIG
HOSE-HEATG. ? 1/0
5.2.4.5
EQUIPM.-CONFIG
FLOW-CONTR. ? 1/0
Water detector
If the water falls below the internal water detector level, the message
WATER-ERROR appears. The pump is then switched to filling mode until
the required level is reached again. The message is also output if the exter-
nal water detector responds.
Don't make any changes
ENTER
Switch on internal water detector
1
Switch off internal water detector
0
The purpose of the external water detector is to monitor the water reserve in
the storage tank. Switch the external water detector off if it is not installed, as
otherwise an error message will be output during operation.
Don't make any changes
ENTER
Switch on external water detector
1
Switch off external water detector
0
Hose heating controller
If dew-point temperatures always lie below the ambient temperature even in
winter, and also if the input temperature is controlled externally, it is possible
to do without the hose heating. In this case it is necessary to switch off the
integrated hose heating controller. Otherwise fault reports will be output and
the unit will cease to output measured values.
Don't make any changes
ENTER
Switch on hose heating controller
1
Switch off hose heating controller
0
Compressed air control
If the air flow rate is controlled by external units that are available on the
premises of the system operator, the integrated compressed air control must
be switched off. This prevents any faults concerning this control from being
reported.
The operator of the system is responsible for ensuring that the correct gas
flow rate is observed.
Don't make any changes
ENTER
Switch on compressed air control
1
Switch off compressed air control
0
Operating Instructions HYGROPHIL® H 4230-12 BA 060207
Advertisement
Table of Contents
