2-Channel Parameters - BARTEC BENKE HYGROPHIL H 4230-12 Ex Zone II Operating Instructions Manual

PROFIBUS
100
7 6
ON free
8.3.6
DaAdr (hex) Identifier
$50 PropValveControlStatus
$54 PumpControlStatus
$55 PumpConfig
$57 EquipmentControlStatus
$58 EquipmentConfig
$53 Limit Task config.
$5a Limit LOW
$5b Limit HIGH
$5c DP Parameter
7 6
ON OpenError
DaAdr $48: T2 correct config
Format: Char
Before you can write this variable you must first change to standby mode.
0x00 = No correction of HT based on the T2 measurement
0x80 = HT is corrected based on T2 (internal temperature) (default)
DaAdr $4c: Timeout activating
Format: Char
Before you can write this variable you must first change to standby mode.
5 4
free free
ON: 1 = timeout monitoring active
0 = no timeout

2-channel parameters

SWNo $50: PropValveControlStatus
Format: Record
End;
StatusChar:
5 4
CloseError Free
ON: 1 = Controller is switched on and working
0 = Controller off
OpenError: 1 = Flow rate too low, valve cannot be opened any further
0 = Valve in working range < maximum
CloseError 1 = Flow rate too high, valve cannot be closed any further
0 = Valve in working range > minimum
Operating Instructions HYGROPHIL® H 4230-12 BA 060207
3 2
free free
Memory-Type
RAM read/write
RAM read/write
EEPROM read/write
RAM read/write
EEPROM read/write
EEPROM read/write
EEPROM read/write
EEPROM read/write
EEPROM read/write
Statuschar: Char;
ControlStatusChar: Char;
ON time; Integer;
OFF time; Integer;
3 2
Free Free
1 0
free free
Read-out Format
hex Record
hex Char
hex Char
hex Char
hex Char
hex Char [2]
dec Float
dec Float
hex/dec Record
1 0
Free Free