Table of Contents
Advertisement
Control
7
6
ON
FullOpen
7
6
ON
Pump on/off
ControlStatusChar:
Used to control the valve within the unit, especially to switch off the valve
temporarily when errors occur. Overrides the PropValveConfig up to reset.
5
4
FullClose
Free
ON:
1 = Controller is switched on and working
0 = Controller off
FullOpen:
1 = Valve completely open (Control) or opened (Status)
0 = No „FullOpen"
ON time:
Time in µs during which the valve is activated.
OFF time.
Time in µs during which the valve is not activated.
DaAdr $54: PumpControlStatus
Format: Char
5
4
FillMode
NormalMode
Control
Control
ON:
1 = The pump is switched on and running
0 = Pump not in operation
Pump on/off:
1 = Pump is currently active
0 = Pump is currently not active
FillMode Control:
1 = Pump is switched to fill mode
0 = No fill mode
SMError:
1 = Error in the stepper motor
0 = No error in the stepper motor
FillMode:
1 = Pump is running in the mode for filling the system
0 = No fill mode
NomalMode: 1 = Pump is running at the speed specified under PumpCon-
0 = No normal operation
DaAdr $55: PumpConfig
Format: Char
Before you can write this variable you must first change to standby mode.
Specification of the pump speed: default 25 -35
Operating Instructions HYGROPHIL® H 4230-12 BA 060207
Status
3
2
ON
FullOpen
3
2
SM-Error
Free
fig
PROFIBUS
101
1
0
FullClose
Free
1
0
FillMode
Nor-
Status
malMode
Advertisement
Table of Contents
