Button Led Configuration; Enable The Button Led; Set Background Light Of The Button - Lightware RAP-B511-EU-K User Manual


  
7. LW3 Programmers' Reference
Query the Clicked Status
Command and Response
Ý GET·/MANAGEMENT/UI/BUTTONS/<btn_ID>/BUTTON.Clicked
pr·/MANAGEMENT/UI/BUTTONS/<btn_ID>/BUTTON.Clicked=<clicked_nr>
Ü
Parameters
Identifier
<clicked_nr> Gives feedback about the number of the quick button presses (max. 1 sec
between the presses). After the clicking, the value restores to default (0)
immediately. It can be set as a condition in the Event Manager when the trigger
should be e.g. a double click.
Example
Ý GET /MANAGEMENT/UI/BUTTONS/BUTTON1/BUTTON.Clicked
Ü pr /MANAGEMENT/UI/BUTTONS/BUTTON1/BUTTON.Clicked=0
Query the Longpress Status
Command and Response
Ý GET·/MANAGEMENT/UI/BUTTONS/<btn_ID>/BUTTON.LongPress
pr·/MANAGEMENT/UI/BUTTONS/<btn_ID>/BUTTON.LongPress=<longpress_status>
Ü
Parameters
Identifier Parameter description
<longpress_status> True, when the button has been
pressing more than 1 sec.
Example
Ý GET /MANAGEMENT/UI/BUTTONS/BUTTON1/BUTTON.LongPress
Ü pr /MANAGEMENT/UI/BUTTONS/BUTTON1/BUTTON.LongPress=false
Parameter description
Parameter values
true: The button has been pressed more than 1sec.
false: The button has been pressed less than 1 sec.
RAP-B511 series – User's Manual
7.6. Button LED Configuration
General parameters
Identifier
<LED_ID> LED identifier (LED1 is behind the BUTTON1)
7.6.1. Enable the Button LED
ATTENTION! If the Button LED is not enabled, the following LED-related settings will not executed.
Command and Response
SET·/MANAGEMENT/UI/LEDS/<LED_ID>.Enabled=<LED_enable>
Ý
pw·/MANAGEMENT/UI/LEDS/<LED_ID>.Enabled=<LED_enable>
Ü
Parameters
<LED_enable> true: The button LED is allowed to light.
false:The button LED is not allowed to light.
Example
Ý SET /MANAGEMENT/UI/LEDS/LED11.Enabled=true
Ü pw /MANAGEMENT/UI/LEDS/LED11.Enabled=true
7.6.2. Set Background Light of the Button
Set the TrueFunction
Here can define how the LEDs behave, when the button is pressed or released. This property takes into
consideration the Set the Button Interaction
according to this setting.
Command and Response
SET·/MANAGEMENT/UI/LEDS/<LED_ID>.TrueFunction=<light_mode>
Ý
pw·/MANAGEMENT/UI/LEDS/<LED_ID>.TrueFunction=<light_mode>
Ü
Parameters
Identifier
<light_mode> Type of the background light.
Example
Ý SET /MANAGEMENT/UI/LEDS/LED11.TrueFunction=1
Ü pw /MANAGEMENT/UI/LEDS/LED11.TrueFunction=1
Parameter description Parameter values
LED1-11
State. If it is true (<btn_ID>.State=true), the LED will light
Parameter description Parameter values
0: Off
1: Low brightness
2: High brightness
3: Blinking
4: Slow blinking
5: Sine pulse
52