Lw2 Commands - Quick Summary - Lightware RAP-B511-EU-K User Manual


  
6. LW2 Programmer's Reference
6.5. LW2 Commands – Quick Summary
General LW2 Commands
Operation
View Product Type
View Device Label
Query Control Protocol
View Firmware Version of the Package
View Firmware for All Controllers
Connection Test
View Serial Number
Compile Time
View Installed Board
Restart the Device
Query Health Status
Restore Factory Default Settings
Network Configuration
Operation
Query the Current IP Status
Set the IP Address
Set the Subnet Mask
Set the Gateway Address
Apply Network Settings
GPIO Configuration
Operation
Set Level and Direction for Each Pins
See in
Command
chapter
6.2.1 {I}
6.2.2 {LABEL}
6.2.3 {P_?}
6.2.4 {F}
6.2.5 {FC}
6.2.6 {PING}
6.2.7 {S}
6.2.8 {CT}
6.2.9 {IS}
6.2.10 {RST}
6.2.11 {ST}
6.2.12 {FACTORY=ALL}
See in
Command
chapter
6.3.1 {IP_STAT=?}
6.3.2 {IP_ADDRESS=<type>;IP_ADDRESS}
6.3.3 {IP_NETMASK=<subnet_mask>}
6.3.4 {IP_GATEWAY=<gateway_address>}
6.3.5 {IP_APPLY}
See in
Command
chapter
6.4.1 {GPIO<pin_nr>=<dir>;<level>}
RAP-B511 series – User's Manual 43