Advanced View Window - Lightware RAP-B511-EU-K User Manual


  
5. Software Control - Lightware Device Controller
Set NTP (Network Time Protocol) settings
▪ Enable NTP makes possible to query time information from an NTP server. It means, that the RAP-B511
is permitted to get time information from an NTP server. The device time synchronized repeatedly and
automatically. In this case, the NTP server address entry field is active, where the IP address or URL
of the NTP server can be typed manually. Click to set to save the address. The current setting is also
displayed.
▪ Enable GET NTP from DHCP server means, when the DHCP server assigns an IP address to the RAP-B511,
its own IP address or URL can be queried, and this address may be saved as an NTP server. In this
case, not necessarily give the IP address or URL manually.
▪ Clicking on the Synchronize now button queries the time information from the NTP server. Time is
updated, when the device is restarted, powered off and on again and in certain time periods.
For more information about the time properties, the see the
All settings are available with LW3 protocol commands, see the details in
programmers reference chapter.
Real-Time Clock in the Device Concept chapter.
Time Settings section in LW3
RAP-B511 series – User's Manual
5.9. Advanced View Window
1
4
5
LW3 protocol Pushing the button results a help window opening which describes the most important
1
help information about LW3 protocol commands in HTML format.
2 Edit mode The default appearance is the read-only mode. If you want to modify the values or parameters,
tick the option. You will be prompted to confirm your selection.
3 Warning mode If this pipe checked in, a warning window pops up when you enable Edit mode.
4 Terminal Commands and responses with time and date are listed in this window. Sent command starts
window with '>' character, received response starts with '<' character. The color of each item depends on
the type of the command and response. The content of the window can be emptied by the Clear
button. If the Autoscroll option is ticked, the list is scrolled automatically when a new line is added.
5 Command line Type the desired command and execute it by the Send button. Clear all current commands and
responses in the Terminal window by the Clear button.
Protocol tree LW3 protocol tree; select an item to see its content.
6
Node list Correspondent parameters and nodes are shown which are connected to the selected item in
7
the protocol tree.
Manual button:
Set button:
Call button:
2
Manual (short description) of the node can be called and displayed in the
terminal window.
Saves the value/parameter typed in the textbox.
Calls the method, e.g. reloads factory default settings.
39
3
7
6