Table of Contents
Advertisement
5. Software Control - Lightware Device Controller
5.5.3. Ethernet
Poe In Ethernet (P1) and PoE Out Ethernet (P2) ports are displayed on this tab. The status of the Ethernet
line can be checked by each ports: the speed and the duplexity of the connection.
The following settings are available for the local port:
Enable / disable the port (for loop protection);
▪
Only on P2 port: Enable / disable PoE;
▪
▪
Reloading
Factory Default
ATTENTION! If the Ethernet port is set to disabled, this may break the connection with the device.
Ethernet tab in Control menu
Settings.
RAP-B511 series – User's Manual
5.5.4. Infra
Infra-Red (IR) receiver options can be found on this tab. There are three submenus are available under it:
IR codes, Ports, and Clear all IR codes.
IR Codes
User can set the name of the IR code, the fingerprint (hash), and the repeat timeout in ms, as well as actions
can be ordered to each IR codes.
IR Codes Window in Control Menu
32
Advertisement
Table of Contents
Troubleshooting
