Table of Contents
Advertisement
6
PRE-OPERATIONAL PROCEDURES AND SETTING
6.2 Pre-Operational Procedures and Setting
A rough procedure for operation is shown below.
Mount the QJ71MT91 to the base unit.
Connect GX Developer and programmable controller CPU
with the cable.
Conduct a hardware test.
Run a self-loopback test.
Set I/O assignment using GX Developer.
Set the intelligent function module switches with GX
Developer.
Connect the Ethernet cable to the QJ71MT91 and connect it
to the network.
Set the operation mode to "Online" using GX Developer.
Set the parameters using GX Configurator-MB or sequence
program.
When using the dedicated instructions, create a sequence
program for communication.
Write the parameters, etc. that are set for the programmable
controller CPU, reset the programmable controller CPU, and bring
it into RUN status.
Conduct a PING test to confirm connection with the target
device.
6 - 2
Pre-operational
procedures
Use utility software
to set parameters?
YES
Set parameters with
GX Configurator-MB.
...... Refer to Chapter 8.
*1
Operation
......
Refer to Section 6.5.1.
......
Refer to Section 6.5.2.
......
Refer to Section 6.6.
......
Refer to Section 6.6.
......
Refer to Section 6.4.
......
Refer to Section 6.6.
......
Refer to Chapter 7.
NO
Set parameters with a
sequence program.
...... Refer to Chapter 9.
......
Refer to Chapter 10.
......
Refer to Section 11.5.
MELSEC-Q
6
6 - 2
Advertisement
Table of Contents
