Dcs2000/En & X-Dcs3000 Operations Guide; Powering The Dcs On/Off; Fault Confirmation; Equipment State Restoration - Honeywell X-618 Operation Manual

1 X-DCS2000/EN & X-DCS3000 Operations Guide
The X-DCS2000/EN and X-DCS3000 Digital Integrated System Manager is hereinafter referred to
as the "DCS".
The X-DCS2000/EN and X-DCS3000 is a broadcasting control device that expands broadcasting
zones and supports multiple sound sources. The DCS integrates with functions such as the sound
source file storage system, network audio broadcasting system, the loudspeaker zone control
system, and the system for monitoring and diagnosing faults. The DCS integrates well and is easily
configured.
Mainly describes the basic operations and precautions of the DCS system.

Powering the DCS On/Off

The system powers on when the power switch is in the "I" position, and powers off when the switch
is in the "O" position.
When the indicator light for the main or standby power supply on the front panel of the DCS turns
green, the respective power supply is working normally.
When the power supply indicator light turns orange, the respective power supply has experienced
a fault. Check whether the power supply is connected correctly and that the DCS power switch is
turned on.

Fault Confirmation

When the system detects a fault, a failure warning tone is heard.
Press the ACK button to confirm the fault. The warning tone stops, and the fault indicator light
turns orange.

Equipment State Restoration

When the system fault has been identified and fixed, the equipment state needs to be restored.
Press the RESET button to reset the equipment state. All fault indicator lights are restored to their
normal states, and the fault warning tone stops.

System Self-Test

The DCS self-test function is activated by pressing the TEST button on the front panel. Operation
steps involve the following:
Press the TEST button to activate the self-test function for the DCS and equipment connected to
the system.
All of the indicator lights that display just one color are turned on. All of the lights that can
display two colors switch back and forth between these two colors. The fault indication buzzer
rings continuously.
Press the TEST button again to stop the self-test program.
Note:

The self-test function does not affect the normal operation of other functions unrelated to the
self-test function. For example, if the self-test function is initiated during voice broadcasting,
the voice broadcast function is not interrupted and the all indicator lights will flicker.

The system times out in one minute by default. If the self-test function occurs for a minute
without being manually halted, the system automatically stops the self-test function.
2